Difference between revisions of "VESM"
Jump to navigation
Jump to search
(Created page with " == Microscope Alignment == === Sideport Alignment === The Filter Carousel should be removed. A pen laser is set up on a vertical mount mounted on tghe stage. The laser sho...") |
|||
Line 27: | Line 27: | ||
Align beam to center of target. | Align beam to center of target. | ||
+ | |||
+ | |||
+ | === Andor Zyla 4.2 === | ||
+ | |||
+ | {| class="wikitable" | ||
+ | !TRIGGER MODE | ||
+ | !FPS | ||
+ | |- | ||
+ | |External | ||
+ | |50.2978 | ||
+ | |- | ||
+ | |External Exposure | ||
+ | |99.968 | ||
+ | |- | ||
+ | |External Start | ||
+ | |50.3951 | ||
+ | |- | ||
+ | |Internal | ||
+ | |50.3951 | ||
+ | |- | ||
+ | |Software | ||
+ | |50.2978 | ||
+ | |} | ||
+ | Trigger | ||
+ | FPS |
Latest revision as of 15:42, 21 April 2016
Microscope Alignment
Sideport Alignment
The Filter Carousel should be removed.
A pen laser is set up on a vertical mount mounted on tghe stage. The laser should centered directly over a ground glass disk with a pin hole that is attached to the objective mount.
Adjust the microscope until center of beam is aligned with target.
Backport Alignment
The Filter Carousel should be installed, and #1 cube should be used.
Install an 8" vertical rod and a small thread rod on top. Only microscope side to side movement should be done.
Recheck Sideport alignment (sans Filter Carousel).
TuCam Alignment
Align the straight-through port, without cameras attached.
Do not have the TuCam dichroic in place.
Use filter cube 1 in the Filter Carousel.
Align beam to center of target.
Andor Zyla 4.2
TRIGGER MODE | FPS |
---|---|
External | 50.2978 |
External Exposure | 99.968 |
External Start | 50.3951 |
Internal | 50.3951 |
Software | 50.2978 |
Trigger FPS